|
|
HP-Compaq ProLiant DL360 G7 (UDIMM) 專用記憶體 | 請選擇喜歡的升級模組
我們堅持採用高品質的原廠顆粒,例如 Samsung, Hynix, Infineon, Swissbit, Princeton and Micron等。 我們模組品質有如各大名廠例宏碁,蘋果,戴爾,惠普,聯想,東芝等。
Upgradeable代理的記憶體模組全帶終身保固。每張訂單的項目都經專人手檢查以確保相容性更多關於Upgradeable的購買保證.
配備細節 | 安裝注意 | 內裡固定記憶體: 0MB
插槽1: 2GB
內裡固定+預設記憶體: 4GB
可升級至: 48GB
記憶體插槽總計: 18
排列: 6 組 x 3 個插槽
| - Per HP, using ECC UDIMMs the DL360 G7 supports up to 48GB of memory.
- There are eighteen (18) memory slots.
- There are three (3) channels per processor; six (6) channels per server.
- There are three (3) DIMM slots for each memory channel; eighteen (18) total slots.
- Memory channel 1 consists of the three (3) DIMMs that are closest to the processor.
- Memory channel 3 consists of the three (3) DIMMs that are furthest from the processor.
- DIMM slots that are white should be populated first.
- Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs).
- Do not install DIMMs if the corresponding processor is not installed.
- If only one processor is installed in a 2CPU system, only half of the DIMM slots are available.
- To maximize performance, balance the total memory capacity between all installed processors.
- It is not required, but it is recommended to load the channels similarly if possible.
- You can only have up to eight (8) ranks installed per channel.
- You can only install two quad-rank DIMMs per channel.
- You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty.
- Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel.
- Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset.
- For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically.
- For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system.
- Low Voltage DIMMs can only be used with Intel Xeon processor 5600 series processors.
- If mixing DIMM voltage is a requirement, please note that the DIMMs will run at 1.5V since all 1.35V are capable of supporting 1.5V operations.
|
|
|
All Makes